Community discussions

MikroTik App
 
razvan_fzl
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 51
Joined: Tue Feb 13, 2007 12:55 pm
Location: Romania

SR 5 strange behavior

Sun Aug 05, 2007 10:38 pm

I want to make a 30km link and i use the following configuration:
p4@1500Mhz 128MB ram, 200W power supply, RB11 + SR5, 90cm offset................ p3@1000Mhz 128MB Ram, 90W power supply, rb11+SR5, 90 cm offset

I use 58000Mhz turbo and the signal level is about -80 but in one night the signal was increasing step by step up tu -62dB! I left it to run all the night and in the morning the signal was -80dBi again :(( ! I checked everything, pigtail, cable, connectors, feeder! I also replaced p4 with rb133 and there was no improvement! I know that the propagation is better during nights, but why only once?
If anybody experienced this issue of something similar, please leave me a message, I would be very grateful!


Best regards
 
razvan_fzl
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 51
Joined: Tue Feb 13, 2007 12:55 pm
Location: Romania

Re: SR 5 strange behavior

Tue Aug 07, 2007 12:32 am

Nobody had problems with SR5?
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 27038
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia
Contact:

Re: SR 5 strange behavior

Tue Aug 07, 2007 2:49 pm

how about interference?
 
razvan_fzl
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 51
Joined: Tue Feb 13, 2007 12:55 pm
Location: Romania

Re: SR 5 strange behavior

Tue Aug 07, 2007 3:27 pm

There is no inteference
 
razvan_fzl
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 51
Joined: Tue Feb 13, 2007 12:55 pm
Location: Romania

Re: SR 5 strange behavior

Tue Aug 07, 2007 4:36 pm

already did without any result
 
razvan_fzl
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 51
Joined: Tue Feb 13, 2007 12:55 pm
Location: Romania

Re: SR 5 strange behavior

Tue Aug 07, 2007 10:51 pm

I tried to replace SR5 with another miniPCI, but this time r52 and the signal was worse! I cheked all the cables, connector again and again, changed the polaization without any result! But the question remains, why did it work just fine???



I hope that somebody will help, I will even pay if somebody resolves this issue!


Best regards