Simple Queues with Bridged Interfaces

Wyoming · Mon Feb 21, 2005 10:06 pm

I have two ethernet interfaces bridged together, Ether1 and Ether2. These interfaces are part of a Bridge interface named bridge. I Then have an IP on the bridge interface. When I set up a Simple queue for a customer with the interface set to bridge, the queue will only show traffic on the tx side and the rx side never shows any traffic.

Any Ideas?

Thanks in advance.

Wyoming · Mon Feb 21, 2005 11:18 pm

Oh. and just so you know. I am running 2.8.17 code.

Wyoming · Tue Feb 22, 2005 8:51 pm

I have this running just not the way we would like to run it. By switching the interface to all, all traffic is then caught by the queues. Why is it when you set the interface to the bridge interface does it only catch the traffic one way?

Thanks

Eugene · Wed Feb 23, 2005 4:00 pm

That's the way bridge works.