Hi all ,

just newbie in MT and have a problem to understand how it works fine...
Coming more from the cisco side so i know trunk, access ports and so on a bit..

so set uo cisco = Router / and Switch with uplinked trunk where all vlans are in ok.
Switch has the access ports and the router should route outside to Internet or if it s needed with ACL one to one other VLAN host.

so what in this scenario is the MT bridge / bridge ports and interface List??

Lets see ...
i have one WAN if = eth1
and one uplink which should transport all vlans from the cisco switch e.g. eth5

is that right that i firtst :
create a bridge with pvid1 and ladmin all frame types..

than i add all vlans to the generated bridge ports : eth5 and all vlans exists incl. vlan 1 ?
are they able to communicate in standard to each other via router? If yes -i have to adjust the Firewall?
What is in this case the Interfaces / Interface List ? i have a wan (ether1) and what should be there for LAN ? ( my LAN should be alone also every vlan should only be free to enter the Internet)
all vlans are vlan interfaces with ip on the router and dhcp for the pool
... thanks for a bit explaining.. read some wiki but didnt understand it really...
what is meant with Interfaces list bridges bridge ports..
Regards
c

viewtopic.php?f=23&t=143620

Hi anav.
thanks first..i read this before..but to be honest...i cant figure out my understanding Problem there :(

https://help.mikrotik.com/docs/display/ ... VLAN+Table (newer)
https://wiki.mikrotik.com/wiki/Manual:Bridge_VLAN_Table (older)

Put your feet in the water and attempt a config.

https://help.mikrotik.com/docs/display/ ... VLAN+Table (newer)
https://wiki.mikrotik.com/wiki/Manual:Bridge_VLAN_Table (older)

Put your feet in the water and attempt a config.

Hi anav..
that´s what i need :) thanks a lot .. i will study it and hope understanding now :)
greets