Hey, Now i got my mikrotik box working whit mac filter and limit list,
and every thing work great Thx MIKROTIK! ;D
but i have a questen that i have wonder over in a long time, but never get a anwer that helps me.
I got 5 ip from my isp and i want to get them tru my router so i can shere them to the computers that need
the internett ip.
why?
I got 10 mbits shere on all 5 ip.
Then i can control the limit on the ips, and i can have a statestikk over it.
so how can i make my router to route this ip adr?

How is your box configured now? If you have been given 5 IPs and a gateway, the routing is already done, just bridge with MT.

My mikrotik router got now one public ip.
But i want to control the other public ip like shape trafik to them.
so then they have to go ttho my gatway.
My gateway now stand and controls my local ip.
whats MT?

MT=Mikrotik

When you make the NAT rule, try S-Nat = your internet pool.

Such as 222.216.115-222.216.115.228/24

Can you write the rule?
Do not understand.

Just write my problem once more:

Its it possible to route the local ip.
And the public ip?

Lets say that i have my router whit one public ip 222.222.222.222
and then i have 5 more public ip accessable 222.222.222.223 - 222.222.222.228.
and its 10 mbits share to all off them

Then i have 7 clients on my network and 5 off them just need local ip,
that have mybe this setup:
IP: 192.168.0.2
Nmask: 255.255.255.0
Router:192.168.0.1

But then i have a webcam and a webserver that need public ip.
what i be able to have done was to have a switch before the mikrotik and set the webcam and server there.
and use the my ISP router but then i have noe control over howe mutch capasy they take off my 10 mbits line
and i can not sett a limit to them. how can i get them to go true my router?

So you'd set up the public IP's as addresses on the public interface of the MT

Then you'd setup a nat rule for the 5 clients that want to connect, for them to use 1 IP address
(assuming Public is the Public/WAN interface and 192.168.1.0/24 is your Private/LAN range)

add chain=srcnat action=masquerade out-interface=Public \
src-address=192.168.1.0/24 comment="masquerade for LAN network" disabled=no

then add direct one-to-one nat rules for the other addresses.

for the local ip that have i dont and work great.

So how to my make a direct nat?
Thx for a fast answer that help me

can you answare me?

for the local ip that have i dont and work great.

So how to my make a direct nat?
Thx for a fast answer that help me

http://wiki.mikrotik.com/wiki/How_to_li ... Local_ones