Hi all.

I have a few wrt54g´s on my network, and found out i can pull wlan signal levels from it via snmp. My problem is it dont update the signal level, only when i manual do a snmpwalk or in another way reload the entire snmp list from the wrt54g.

One of the link labels looks like this:
Signal -[oid("1.3.6.1.4.1.2021.255.3.54.1.3.32.1.26.1")]dB
Rx: [Interface.InBitRate]
Tx: [Interface.OutBitRate]

The Rx/Tx updates just fine, but the Signal lavel dont. Its static untill i do a manual snmp reload.

How do a i get the dude to update the oid value, so the signal level change in the network map by it self ?

Regards
Brian.