Hey folks,

I'm trying out to set-up a metarouter on the LtaP and the metarouter it gets stuck on booting state.
Is the ltaP capable of creating a metarouter or Im just messing around.

Kind regards

With only 2M of storage free?

With only 2M of storage free?

I'm a newbie, with 2MB free you mean in the LtaP mini, or the virtual machines?

What I get in the output of /metarouter print

[xxxx@MikroTik] > /metarouter print
Flags: X - disabled
# NAME-------------------------------------------------------------------------------------------------------------------------MEMORY-SIZE--DISK-SIZE----USED-DISK STATE
0 mr0-----------------------------------------------------------------------------------------------------------------------------32MiB--------------32000kiB----------3kiB booting

/system resource print ?

/system resource print ?

uptime: 1m14s
version: 6.47.10 (long-term)
build-time: May/31/2021 09:54:59
factory-software: 6.44.6
free-memory: 40.5MiB
total-memory: 64.0MiB
cpu: MIPS 24Kc V7.4
cpu-count: 1
cpu-frequency: 650MHz
cpu-load: 13%
free-hdd-space: 3600.0KiB
total-hdd-space: 16.0MiB
write-sect-since-reboot: 200
write-sect-total: 1063
bad-blocks: 0%
architecture-name: mipsbe
board-name: LtAP mini LTE kit
platform: MikroTik

free-hdd-space: 3600.0KiB
total-hdd-space: 16.0MiB

By this, you meant that there is not enough storage for the Metarouter? In this case I must create one which fits the available memory?
Or should I, somehow , free used memory?

I tried to create a smaller Metarouter, but minimun memory-size must be 24MB.

Sorry for the question, but I would like to understand how to behave.

Thank you, rextended.

Like all the other RouterBOARD, all functions are available everywhere (some exception for architecture applied)
but on the other side, not on all devices you can use some services because storage or ram are not sufficient.
I do not think than 2/3MiB free NAND or Flash suffice for both metarouter and regular working of the routerboard.

Like all the other RouterBOARD, all functions are available everywhere (some exception for architecture applied)
but on the other side, not on all devices you can use some services because storage or ram are not sufficient.
I do not think than 2/3MiB free NAND or Flash suffice for both metarouter and regular working of the routerboard.

Okey, I get it.

Thank you for your time rextended!!!!