Доброго времени суток.
Есть объяснение этому состоянию?
CRS212-1G-10S-1S+ - Загрузка процессора 20-30% в холостом режиме.
===================================
Good day.
There is an explanation to this state?
CRS212-1G-10S-1S + - 20-30% CPU load at idle.
CRS212-1G-10S-1S+ - Загрузка процессора 20-30% в холостом режиме.
You do not have the required permissions to view the files attached to this post.
Re: CRS212-1G-10S-1S+ - Загрузка процессора 20-30% в холостом режиме.
Я его снял с задачи, где его состояние 100% загрузки процессора не спускалась.
Пришлось заменить до выяснения причины загруженности процессора
==============================================
I took him to task, where his condition is 100% CPU usage did not go down.
I had to replace up to determine the cause Processor
Пришлось заменить до выяснения причины загруженности процессора
==============================================
I took him to task, where his condition is 100% CPU usage did not go down.
I had to replace up to determine the cause Processor
Re: CRS212-1G-10S-1S+ - Загрузка процессора 20-30% в холостом режиме.
I think something is wrong with newer than v6.15 routeros.
Based on this thread i downgraded (make sure you backup license key!!!)
and with routeros 6.15 now my crs112 (same 400MHz cpu) is USABLE.
http://forum.mikrotik.com/viewtopic.php ... 22#p499480
I hope the problem will be sorted out soon.
But look at "sector writes", it seem to wite way too much..perhaps change Logging, to memory and less rows.
Just an idea.
Based on this thread i downgraded (make sure you backup license key!!!)
and with routeros 6.15 now my crs112 (same 400MHz cpu) is USABLE.
http://forum.mikrotik.com/viewtopic.php ... 22#p499480
I hope the problem will be sorted out soon.
But look at "sector writes", it seem to wite way too much..perhaps change Logging, to memory and less rows.
Just an idea.