Dynamic NAT
Posted: Tue Nov 03, 2015 10:39 am
This is the best way to do dynamic NAT set public rang on wan interface and add NAT rule like
I use 6 public IP
Then that add NAT rule
[/code]
chain=srcnat action=src-nat to-addresses=x.x.x.x1 - x.x.x.x6
src-address-list="privet-network " out-interface=WAN log=no log-prefix=""
[/code]
I use 6 public IP
Code: Select all
ip address add address=x.x.x.x1/x interface=WAN
ip address add address=x.x.x.x2/x interface=WAN
ip address add address=x.x.x.x3/x interface=WAN
ip address add address=x.x.x.x4/x interface=WAN
ip address add address=x.x.x.x5/x interface=WAN
ip address add address=x.x.x.x6/x interface=WAN
[/code]
chain=srcnat action=src-nat to-addresses=x.x.x.x1 - x.x.x.x6
src-address-list="privet-network " out-interface=WAN log=no log-prefix=""
[/code]