The 5.8mhz link set routed ospf to the routerboard. The routerboard has a 2.4mhz ap and a 900mhz ap atached to it's ethernet port.

I have a subnet /27 assigned to the bridge and have included the ether1 and the 2.4mhz wlan as ports.

Clients on the ethernet1 and 2.4mhz both have internet access and I can access them from my office through the 5.8mhz link.

However, clients on the ethernet and on the 2.4mhz can't reach each other. Normally this wouldn't be an issue. However, one of my tech's on the 2.4mhz link also helps montior the system for me. And he is unable to moniotor the 900mhz clients attached to the ethernet port.

Why do you belive he can not reach the clients on ether1, and what can I do to correct this?

-Michael