CRS125G and RB1100AHx2 Trunk and Port based VLANs
Posted: Sun Dec 13, 2015 9:52 pm
Hi All,
I have two regions A and B
in Region A i have RB 1100AHx2 with (ether3) 1G wireless link (AP) connected to Region B
in Region B i have CRS125G connected with (ether 24) as wireless link (Station).
I have vlans (101-113) in RB1100AHx each with different network and subnet.
I want to isolate each port in region B and make a port based VLAN and let's say the (ether24) will be trunk.
I have followed the guides on this Wiki : http://wiki.mikrotik.com/wiki/Manual:CR ... Based_VLAN
But it didn't work for me and i can't make more test on the link because there is a real users and traffic going on it.
Note: i have the same procedure working on Cisco Catalyst 2950T but i want to replace it with CRS125-24G-1S.
Many thanks,
Areeb
I have two regions A and B
in Region A i have RB 1100AHx2 with (ether3) 1G wireless link (AP) connected to Region B
in Region B i have CRS125G connected with (ether 24) as wireless link (Station).
I have vlans (101-113) in RB1100AHx each with different network and subnet.
I want to isolate each port in region B and make a port based VLAN and let's say the (ether24) will be trunk.
I have followed the guides on this Wiki : http://wiki.mikrotik.com/wiki/Manual:CR ... Based_VLAN
But it didn't work for me and i can't make more test on the link because there is a real users and traffic going on it.
Note: i have the same procedure working on Cisco Catalyst 2950T but i want to replace it with CRS125-24G-1S.
Many thanks,
Areeb