MikroTik

I have bought a new hap lite for r&d purposes. First I tried to remove the default setting which cost me a lot of time to fix as hap lite comes with RouterOS 6.25.. it didn't boot after i tried to reset it..so i have to do a netinstall to get it working again. anyway long story short... i have configured it but i cannot use the internet when i assign a IP on my laptop. i can ping the gateway Ether4 (192.168.1.254). Ether1 is connected via pppoe. and i can ping google from the mikrotik but cannot get internet in my laptop. i have attached a picture with it so that the experts can look in to it..i am not an expert but i have knowledge how to configure a mikrotik with basic settings. i can't find the reason why i cant use the internet in my laptop? I look forward to all of your expert opinion.

Hello,

try adding ether1-Wan as Out-interface under ip->firewall->NAT

Try this instead of your NAT rule. Do you have any firewall rules ? Try to disable them for test if above rule does not help.

Apologies, it should be Wan-1-out as bartoszp stated, since that is your pppoe interface name.

I would like to see how the dns server and dhcp server and stuff around are set. Sure the masquerade should be corrected but I don't believe it is the reason. Can you ping to the 8.8.8.8 ip address from your pc?

Hello,

try adding ether1-Wan as Out-interface under ip->firewall->NAT

Thanks man...it worked. I have assigned a Wan as out interface on ip-->firewall-->nat. Thank you once again. But i still couldn't find a good reason why it didn't work with the default 0.0.0.0/0 masquerade.

I would like to see how the dns server and dhcp server and stuff around are set. Sure the masquerade should be corrected but I don't believe it is the reason. Can you ping to the 8.8.8.8 ip address from your pc?

Problem solved. I have added out interface on the ip>firewall>nat.

But i am still confused why the default 0.0.0.0/0 masquerade didn't worked..any ideas on that

We do not see all this rule on the screenshot.
Maybe there was 192.168.1.254 as source set instead of 192.168.1.0/24 subnet.
It explains why router have been able to ping "the world" but devices on LAN not.

We do not see all this rule on the screenshot.
Maybe there was 192.168.1.254 as source set instead of 192.168.1.0/24 subnet.
It explains why router have been able to ping "the world" but devices on LAN not.

No..It was set correctly with 192.168.1.0/24 subnet.I am still confused why it didn't work...

I should be easier to analyze the problem if you will send all your configuration. Just export it. Remeber to remove all usernames and passwords.