MikroTik

Hello

I have a problem with winbox software.
The routerboard is a 532 with a 8602 radio 400mW.
I run the winbox.exe and i can connect to the routerboard 532, but some functions are disable.
Ej: I put an ip address to the bridge and reboot. After, I connect via winbox but I cannot see the ip address or I cannot see the ports and I cannot add the ports to the bridge....

Than you very much...

1) Use the latest Winbox version. The latest Winbox version is available on http://demo2.mt.lv

2) Make sure that used login has enough permissions.

In your example, you will loose connection to the MT as the bridge is not assigned ports yet. Best to do the basic intial config with serial terminal.

I don't know for sure about the 532, but other routerboards I use have most of the packages disabled out of the box. Check system/package to see...

The rb 532 software is 2.9.30 and all packages are active.
However, I only can to configure the rb if I´m connected in the same switch. The options are disabled and I cannot to configure any option.
I´m really desperate...


Thanks

The rb 532 software is 2.9.30 and all packages are active.
However, I only can to configure the rb if I´m connected in the same switch. The options are disabled and I cannot to configure any option.
I´m really desperate...


Thanks

---
Hello Harpo,

Can you try connect to your router with MAC-Winbox in v2.10 [v2.9.30] is available.

regards
Hasbullah.com
---

Hi Balimore

The rb software is v2.9.30 and I`m connecting throught the lastest winbox version. The problem is the same.
Now, I connect via winbox(port 20561) and the problem is the same.
But, if I connect throught dude with winbox (port 8291) the problem is resolute. In this manner it`s working correctly.


Thanks...