dear guys, i have a radio (UBNT) behind my mikrotik device, and long ago i had it as router, putting pppoe over it. i had no problem accessing it through my mikrotik. but since i moved the pppoe for some reason to my mikrotik, and set the radio as bridge, i can only access my radio when i connect the cable directly, but with mikrotik in the way, i have no access to it. the mikrotik it self can ping to radio...

i have eter 1 connected to radio with ip range of 192.168.1.0
and i have eter 2 as master for range of 192.168.0.0 and other port as it's slaves.
also i have run a bridge that my pppoe is work in this interface

now i want to access 192.168.1.1 from 192.168.0.4...

Hello
Please draw your scenario

i want to be able to monitor my UBNT....
But i can't access it.

i also just now, notice that if i ping through interface eter 1, i have timeout though the 192.168.1.1 is behind eter 1. but on bridge i have ping

Hi Guys

was this resolved? I am having a similar issue with a 1100AH router. I have a backhaul device( Dragonwave) connected to 1 port on the router, that port serves as its GW and I can access the device only when directly connected to THIS router. On the rest of the network pings fails and trace routes die at the Gateway on the router in which the device is connected to. I also have other devices on the same network that doesnt suffer from this issue and also this issue recently started. As far as i know nothing changed. Any points to check would be greatly appreciated.

not for me...