GNS3 CHR Interface Naming
Posted: Fri Sep 23, 2016 9:47 pm
Hi
I have a basic question. I use MIkroTik CHR on GNS3 for r&d at home. When i use the CHR image on vmware the interface names comes normally (ie: ether1,ether2...). But the same image on GNS3 start from ether6, ether7 and so on. Does any one know the reason why this is happening as sometime i copy paste the configuration to check. The different interface naming is causing a headache. I cannot find a solution. Thanks. No bad comment please.
I have a basic question. I use MIkroTik CHR on GNS3 for r&d at home. When i use the CHR image on vmware the interface names comes normally (ie: ether1,ether2...). But the same image on GNS3 start from ether6, ether7 and so on. Does any one know the reason why this is happening as sometime i copy paste the configuration to check. The different interface naming is causing a headache. I cannot find a solution. Thanks. No bad comment please.