MikroTik

Hello,

there is (serious) bug in SwOS 2.0 and/or CSS106 HW, that renders management IP in tagged interface unusable. For some reason (error in switch programming, I suppose) device returns frames tagged with wrong VID. It (probably) works for VIDs 2-15 (tested 2, 3 and 15) then something gets messed up. For VIDs 16 and 17 I'm getting untagged frames, for VID 906 - returned frames are tagged with 778 and for 908 -- with 780.

I hope it's trivial bug that can be quickly and easily fixed.

Regards,
fb

Hi.

Confirmed.
Management configured in vlan 690, on tagged port, receive ARP responses with VID: 514. Also after this configuration i am unable to save configuration to file.
Firmware: Current Installed Version 2.0 (built at Thu Jan 26 2017 12:43:10 GMT+0100 (CET))
For us, It is a serious bug. We have strict policy about management vlan's and so are unable to use new CCS106-5G-1S.

Best regards.
Michal.

Same problem. A switch without VLANs is a router without ip route ...

According to my experience VLAN 256 is working, 512 too, 128 no I do not try 1024

Any response from Mik ?

Any response from Mik ?

I'm not sure anybody actually complained to Mikrotik. Can you please write to support@ ?
And, by the way, there is absolutely no need to post the same message in multiple topics.

Any response from Mik ?

I'm not sure anybody actually complained to Mikrotik. Can you please write to support@ ?
And, by the way, there is absolutely no need to post the same message in multiple topics.

I did write, no response ...
I made a mistake then deleted the post on the other topic quite soon!!

Mikrotik support has replied to my email:

"We have found the problem and are working on a fix."

Hi

Super but any body know when will be fixed?

Hi.

I've received 2.1rc3 firmware for testing, and tagged management seem to work. Have not done extensive testing. Just looked if it is working.
One other minor problem still exist.

BTW. Found SNMP v2c support and 64bit counters in this FW.
Thanks Guys.

M.

I need some version of this right now as we are out regular RB260GS units and have to deploy the new SWOS 2.0 version with broken VLAN.

Can someone give me the RC version where VLAN works?

Also, I don't see any upload firmware tab or means to update the new 2.0 hardware RB260GS versions.

How do you upgrade firmware??

Download page has a release version of 2.1


Sent from my Nexus 5 using Tapatalk

What is the method to update these?

I don't see an upload section anymore??

What is the method to update these?

I don't see an upload section anymore??

There is an 'Upgrade' tab rightmost on the interface.
Scroll to the bottom of this upgrade page for the option to manually upgrade the firmware.