How to enable interface

rinoel · Fri Nov 24, 2006 6:23 pm

Hi there, I am a newbie in MT, my question is: How can i enable an interface (wlan1), under interface>print it shows ether1 enabled, but wlan1 disabled (x), please help me to enable the wlan1

Fri Nov 24, 2006 7:09 pm

'interface enable wlan1' or 'interface wireless enable wlan1'.
I suggest you to start from MikroTik RouterOS documenation, that contains a lot of useful information,
http://www.mikrotik.com/testdocs/ros/2.9/

mipland · Sat Nov 25, 2006 2:49 am

/interface print

give a look on the id of your wlan1, it's on the first column on the left, then, if your wlan1 had a "1" id, give on the CLI:

/interface set 1 disabled=no

Hint:
when you press the key "?", a menu appears with all the possible functions to use on the context which you are.

rinoel · Sat Nov 25, 2006 10:51 am

well thnx, it`s ok now, i have enabled it, my next question is, from wlan1 I am getting the signal (internet) from my ISP, i have ether1 to, so i want to do something like that, accepting the signal with wlan1 from my ISP and transmitting it from ether1 to my clients, I read the manual about this but not understood how to do this, please help me if u want ???

mipland · Sat Nov 25, 2006 1:30 pm

You have to make a new bridge, and then add the wlan1 and the ethernet to it. The IP address have to be configured on the bridge, not on the eth1 nor wlan1.

How to enable interface

How to enable interface

Who is online