LCD blinking on RB 2011 UiAS-2HnD-IN
Posted: Fri Jul 28, 2017 3:38 pm
Hi
After update RouterOS to 6.40 on Mikrotik RouterBoard RB 2011 UiAS-2HnD-IN LCD screen after boot is blinking.
Dont matter is ON or is OFF
Blinking with status led of ether1 alternately
If I unckeck or ckeck "Enabled" option - blinking stoped.
If I unplug UTP cable from ether1 and put in other ports then blinking stopped. If i plug in back then blinking started again.
Short video
With Enabled LCD
https://www.youtube.com/watch?v=zG1KBcTXPUI
With Disabled LCD
https://www.youtube.com/watch?v=LKDG37Ve3TI
After update RouterOS to 6.40 on Mikrotik RouterBoard RB 2011 UiAS-2HnD-IN LCD screen after boot is blinking.
Dont matter is ON or is OFF
Blinking with status led of ether1 alternately
If I unckeck or ckeck "Enabled" option - blinking stoped.
If I unplug UTP cable from ether1 and put in other ports then blinking stopped. If i plug in back then blinking started again.
Short video
With Enabled LCD
https://www.youtube.com/watch?v=zG1KBcTXPUI
With Disabled LCD
https://www.youtube.com/watch?v=LKDG37Ve3TI