changing in address list
Posted: Wed Aug 09, 2017 3:47 pm
hi guys
recently after using Cisco IP SLA with Mikrotik on one side (to create 2 link failover), I noticed that sometimes my route get unreachable after diagnosing I figured that the problem is in the address list.
one of my routes IP address interfaces change to eth1("AP 1") automatically caused my route be unreachable (it's very weird )
(also, I created a loopback bridge to assign my public IP addresses)
could you plz help me on this
recently after using Cisco IP SLA with Mikrotik on one side (to create 2 link failover), I noticed that sometimes my route get unreachable after diagnosing I figured that the problem is in the address list.
one of my routes IP address interfaces change to eth1("AP 1") automatically caused my route be unreachable (it's very weird )
(also, I created a loopback bridge to assign my public IP addresses)
could you plz help me on this