Installing RouterOS on Wrap Board

mspencer · Mon Dec 04, 2006 4:00 am

I am trying to install RouterOS on a Wrap Board. I have downloaded Netinstall but after I run it, it never comes up with a list of drives to install to. The Routers/Drives Field Stays Blank. Anyone know how to get past this?

Thanks
Mark Spencer

janisk · Mon Dec 04, 2006 10:12 am

set wrap to boot from net and set bootp protocol, if that is not available for you - just install using cdrom. also you have to configure netinstall correclty (set the ip address to set to client to connect to your netinstall station)

Mon Dec 04, 2006 10:20 am

actually none of the both are supported on the mentioned device. You have to use a USB-CF adapter, and install with netinstall on the CF while it's attached to your windows. Then just move the CF to your board.

janisk · Mon Dec 04, 2006 10:59 am

oops

my bad

cmit · Mon Dec 04, 2006 12:18 pm

And remember that you NEED to install the routerboard package for the reboot function to work on a WRAP!

Best regards,
Christian Meis

mspencer · Mon Dec 04, 2006 3:40 pm

Thanks Guys, that worked for me.