Routing Interface or ip to WAN2 PPPoE client super slow if main gateway is still active
Posted: Tue Oct 03, 2017 5:07 pm
This is my setup
So when adding mangle rules to rute a single ip or interface to use the PPPoE-Client gateway using routing mark should work, but it is super slow, like 4000ms ping and 0.18 download in speedtest. Only IF the main gateway is enabled. If i disconnect the main modem and all pcs switch to using the PPPoE client it starts working as expected.
Not sure if im missing something here or it is a bug or what.
Code: Select all
/ip firewall nat
;;; fibertel
chain=srcnat action=masquerade out-interface=ether1-Fibertel log=no log-prefix=""
;;; speedy wifi
chain=srcnat action=masquerade routing-mark=speedywifi src-address=10.5.50.0/24 out-interface=PPPoE-Speedy
log=no log-prefix=""
;;;speedy
chain=srcnat action=masquerade out-interface=PPPoE-Speedy log=no log-prefix=""
/ip firewall mangle
;;; speedy wifi
chain=prerouting action=mark-routing new-routing-mark=speedywifi passthrough=no connection-state=""
in-interface=wlan2 log=no log-prefix=""
/interface pppoe-client
0 R name="PPPoE-Speedy" max-mtu=auto max-mru=auto mrru=disabled interface=ether5-Speedy user="*******"
password="*******" profile=default keepalive-timeout=disabled service-name="" ac-name=""
add-default-route=yes default-route-distance=4 dial-on-demand=no use-peer-dns=no
allow=pap,chap,mschap1,mschap2
/ip route
0 A S 0.0.0.0/0 PPPoE-Speedy 1 <- routing mark = "speedywifi"
1 ADS 0.0.0.0/0 181.165.125.1 1
2 DS 0.0.0.0/0 PPPoE-Speedy 4
4 ADC 10.5.50.0/24 10.5.50.1 wlan2 0
5 ADC 181.165.125.0/24 181.165.125.211 ether1-Fibertel 0
6 ADC 186.130.64.1/32 186.130.68.28 PPPoE-Speedy 0
7 ADC 192.168.0.0/24 192.168.0.1 bridge-local 0
Not sure if im missing something here or it is a bug or what.