MikroTik

Hi Everyone,

We seem to be having an unusual issue where on our links between CCRs is only showing a very small amount of traffic when being torched. Torch works on customer pppoe sessions and anything without ospf / mpls enabled on it.

I have checked fastrack is off, MTU looks good.

Any ideas?

For example an interface would show 180mbps/40mbps throughput (confirmed by rates in interface list) but when you torch the said interface there is literally only 3 - 10mbps showing in each direction.

I have tried to track if the traffic has a different source / destination origin but it doesn't seem to coincide with anything.

Thanks in advance,

Sam

Such behaviour can occur when the port is part of switch. Some ccr does have a switch so it might be the case.

Thanks for the reply - yeah i did think this may be the case and some ends are in a switch group in CCR1009 - it is doing it on links were they are between CCR1036 not in switch groups though.

Sam