Hi Guys,

I have a question regarding setting up a routed network using two SXTs and two Routers.

Do I have to bridge both ether1 and wlan together or is there another way without bridging interfaces using IP routes?

SXT1
Wireless bridge mode
IP on Lan interface is 10.0.0.2/29
IP on Wlan interface is 178.168.0.1/30

SXT2
Wireless Station bridge mode
IP on Lan interface is 10.0.0.3/29
IP on Wlan interface is 178.168.0.2/30

Router 1
IP on Lan connected to SXT1 IP interface is 10.0.0.1/29
Loopback 10.255.255.1/32
OSPF setup
MPLS setup
VPLS setup
PPPoE setup

Router 2
IP on Lan connected to SXT2 IP interface is 10.0.0.4/29
Loopback 10.255.255.2/32
OSPF setup
MPLS setup
VPLS setup
PPPoE sertup


Thanks in advance

Guessing you're talking about bridging the ether and wlan on the SXT together? That's the way we have all our sites setup up so should work unless you set up OSPF on your SXTs as well.