Page 1 of 1
CCR1009- PSU2 enetered state FAIL
Posted: Thu Sep 06, 2018 10:03 pm
by brg3466
Hi all,
I have a CCR1009 and I only connect the power to the PSU1, but when I reboot, I found the log shows that " PSU2 entered state FAIL". I didn't connect anything to PSU2, how come it failed ?
Can this message be neglected or I have to fix it ?
Thank you!
Re: CCR1009- PSU2 enetered state FAIL
Posted: Thu Sep 06, 2018 10:17 pm
by xvo
It failed to provide power to the unit.
Obviously the reason of this failure is that you didn't connect it to the power outlet
Re: CCR1009- PSU2 enetered state FAIL
Posted: Fri Sep 07, 2018 6:07 am
by brg3466
thank you for the reply ! So I over-reacted. I don't need to worry about it ?
Re: CCR1009- PSU2 enetered state FAIL
Posted: Fri Sep 07, 2018 9:16 am
by xvo
thank you for the reply ! So I over-reacted. I don't need to worry about it ?
My CCR1009 behaves the same way.
But if you haven't done that already, I suggest you to temporarily switch the power cord from PSU1 to PSU2 to know for sure that they are both working properly
Re: CCR1009- PSU2 enetered state FAIL
Posted: Mon Feb 17, 2020 1:53 am
by Heinerphilipp
I have a similar issue... Just started.
My router is powered over POE and not over power supplies. So message PSU1 entered state fail is a bit strange...
I also have two clients that log on/off for ever... PPPoE is employed.
I would send a screenshot, if I knew how...
Heiner Philipp