MikroTik

Please any one help me about configure vlan in CRS317-1G-16S+RM switch.

Not enough information. What are you trying to accomplish?

I want to try passing VLAN individually. But I don't configure how do the process.

Hard to understand what you're trying to do. A good starting point is to read in the wiki: https://wiki.mikrotik.com/wiki/Manual:Interface/VLAN
You also might find this useful: https://wiki.mikrotik.com/wiki/Manual:B ... _switching

You're still not really telling us what you are trying to accomplish (we're not mind readers). Also, you are asking about this in the SwitchOS section of the forum. Can I assume you are doing this on your CRS317 operating in SwitchOS as opposed to RouterOS?

Dear I can tell about is, I don't set any access vlan or gateway on switch in Mikrotik SwOs.

edit" post deleted operator error swos working fine on 2.19 260gs model.

SWOS - Should be easy - however it is the most confusing thing I have ever seen !
No default gateway on management ?
No subnet mask on management ?

I've been doing networking and switches for decades. I thought SWOS would be a don't bother to read the documentation and just wing it - nooooooo not so.

The documentation is poor to nill on making trunk ports and some mode addess ports and putting the management IP on a specific vlan other than default.
Ether it is goofey and much harder than it should be , or the documentation is lacking important information - or it's just me ....

North Idaho Tom Jones

edit: post deleted 260GS works fine , just operator error (ie me).

No it is not you.
The switch locks one out consistently without explanation and when you reset to defaults it resets to the firmware it came with, vice the defaults of the current firmware.
I feel like a sucker that bought their switch thinking SwOS was going to be similar in quality to Router OS.

I've got literally thousands of Mikrotiks running ROS. I thought I would give SwOS a try for three switches I need in the network. Holey Moley, The Mikrotik CRS317-1G-16S+RM running SwOS is just plain nuts to configure. I'm going back to ROS on my three Mikrotik CRS317-1G-16S+RM devices. As a router, ROS is pretty strong. As a switch, ROS is also not exactly easy to configure (using the switch chip) when you need 4 trunks and 3 sets of 4-ports configured mode-access on three different vlans. ROS software bridging is just barely OK for less than 300 meg layer-2 networks. I know ROS can do it, just got to read some on-line docs to properly figure out ROS switching at the layer-2 level with the switch chip. However again , ROS switch configuration and on-line docs are also very limited and a little confusing.

If SwOS had a CLI interface similar to Dell and Cisco, then it would have a chance of being decent - without it , it just plain blows !

North Idaho Tom Jones

On the positive front, they work well as unmanaged switches.

I have five switches running SwitchOS (listed in my signature) without any problems at all. Only thing fancy I'm doing is VLANs, but all of them have over a dozen VLANs at my house...

How best to contact you then as I suck eggs when it comes to using the basic 260GS switch??