Page 1 of 1
LOW Signal over 4000msnm
Posted: Sat Mar 03, 2007 4:16 am
by emcentellas
Hello
i have this configuration
AP= RB532+SR2+Omni 15dbi
cliente1= edimax 23dbm+ panel 14dbi distancia= 700mts sigmal = -86
cliente2= ediamx 23dbm+grilla24 dbi distancia = 6km signal= -88
any idea for this
Saludos
Posted: Sat Mar 03, 2007 6:15 am
by wildbill442
15dBi omni! jesus, whats the vertical beamwidth on that?? 1 degree?
Posted: Sat Mar 03, 2007 7:44 am
by mneumark
emcentellas,
What is your noise floor look like?
Re: LOW Signal over 4000msnm
Posted: Sat Mar 03, 2007 4:46 pm
by Diganet
Hello
i have this configuration
AP= RB532+SR2+Omni 15dbi
cliente1= edimax 23dbm+ panel 14dbi distancia= 700mts sigmal = -86
cliente2= ediamx 23dbm+grilla24 dbi distancia = 6km signal= -88
any idea for this
Saludos
How is that omni polarized? With those radios and antennas you should get much much better signal levels..
/Henrik
noise floor
Posted: Sun Mar 04, 2007 2:42 am
by emcentellas
hello mneumark
noise floor is
-79 dBm
saludos
Posted: Sun Mar 04, 2007 6:11 am
by jo2jo
that is your issue right there...you need to switch channels until you find one well above the actual Rx of the ap you are connecting too
Posted: Sun Mar 04, 2007 10:53 am
by mneumark
emcentellas,
jojo is right. I would survey your area again and see if there is another channel you can use that has a better noise floor. Remember the farther away from 0 the better.
Your noise floor right now is at -79 and your clients are -86-88. So your best bet is to see if you can find a channel with -90 to -100