MikroTik

Hello,

i want to connect my RB3011UiAS-RM and an CRS24P-4S+RM over 1m SFP+ Cable S+DA0001
whats the right configuration and can i use 10Gb Speed ? the RB3011 dont Support 10Gb over SFP Modules but maybe over this Cable ?

Thanks!

Well, the 3011 has only a SFP slot, NOT SFP+ slot!
This means that whatever you plug in it (see compatible list of optics & cables for the 3011) you only ever will get 1Gbps link for Ethernet type of traffic!
SFP specifications are based on IEEE802.3 and SFF-8472. They are capable of supporting speeds up to 4.25 Gbps, so in theory a device with only a SPF "slot" could also support 4Gbits/sec FIBRE-CHANNEL protocol for example. (but this is not relevant for Mikrotik 3011 here)

The 3011 is a sweet router, but no need at all for any 10Gbit/sec interface as it can only switch 1Gbits internally...routing performance even less...

you need rb4011

Ok, thanks!

there are any benefits for me to use the S+DA0001? no or? maybe that i have one free port more on the switch thats not bad. is the response time or something better ?
i need to go in the next year to RB4011 or something faster... but jet my isp connection dont need more speed than the gbit....

Ok, thanks!

there are any benefits for me to use the S+DA0001? no or? maybe that i have one free port more on the switch thats not bad. is the response time or something better ?
i need to go in the next year to RB4011 or something faster... but jet my isp connection dont need more speed than the gbit....

No benefit except like you say 1 port extra to use. So you keep to have 2 x 5 actual switch-ports for devices and use the SFP as "Uplink" (1Gbps) to the CRS.

Ok, and i read lower Energie 1,5 to 5watt, amazing haha


@honzam
The rb4011 will not support the S+DA0001 Cable ?

„ RB4011 -- Only active Direct Attach Cables (MikroTik S+AO0005) are supported. Passive DAC (MikroTik S+DA0001/S+DA0003) are not supported.“

Sorry, my CRS328-24P-4S+ is arrived... is it right that i must turn off the auto Negotiation on RB3011 and CRS328 for link on ?

And why i cant update over the webgui with SwOS ? they say no internet connection but they have one over dhcp and become an ip.