Page 1 of 1
OSPF+MPLS+VPLS
Posted: Fri Jan 03, 2020 2:06 am
by airmax
vpls one side is up and other end is down help please, i have checked LDP and MTU on both routers but still its the same and i m stuck
Re: OSPF+MPLS+VPLS
Posted: Sun Jan 05, 2020 1:13 pm
by brixsat
We need more info
so we can help.
Please state config, cenario, etc...
Re: OSPF+MPLS+VPLS
Posted: Mon Jan 13, 2020 3:49 pm
by Anumrak
Are you sure you have LDP enabled on every LSR between LER's?
Re: OSPF+MPLS+VPLS
Posted: Mon Jan 13, 2020 5:08 pm
by jprietove
vpls one side is up and other end is down help please, i have checked LDP and MTU on both routers but still its the same and i m stuck
Check IP address (/32) of both ends appears on routing table
Re: OSPF+MPLS+VPLS
Posted: Sun Jan 19, 2020 10:44 pm
by StubArea51
vpls one side is up and other end is down help please, i have checked LDP and MTU on both routers but still its the same and i m stuck
Be sure that the transport address is set on the LDP interface or global LDP options. VPLS requires dynamic targeted LDP sessions which must have a consistent transport address set.
Here is an example of working config for VPLS.
https://stubarea51.net/2018/04/23/wisp- ... c-subnets/