Page 1 of 1
problems with mikrotik router RIC 522 routerboard 112
Posted: Fri May 04, 2007 1:44 pm
by davidefulvio
Hi
My name’s Davide Cocco ,I’m a student in electronic engineering in University of Cagliari(Italy) and I work with router mikrotik for my thesis and I have these problems:
When I launch winbox I can’t access a lot of menu, for example menu: ip\address, so I can’t change ip\address of Ethernet interface(ether 1) which have ip address 0.0.0.0 and also the router disconnect every 30 seconds.
I hope in a your aid
Thanks
Davide
Re: problems with mikrotik router RIC 522 routerboard 112
Posted: Fri May 04, 2007 1:57 pm
by balimore
---
i think, you have ID just 'read-only' permission.
try login in with Mac-Telnet or Mac-Winbox when you have problem to check your status of your group ID.
that command excute type mac-telnet [CLI]:
regards
Hasbullah.com
---
Posted: Fri May 04, 2007 2:15 pm
by davidefulvio
i can't connect with telnet because the internet interface have ip address 0.0.0.0
Posted: Fri May 04, 2007 4:25 pm
by balimore
i can't connect with telnet because the internet interface have ip address 0.0.0.0
---
yes ofcourse, you can connect to them with mac-telnet by download this link first:
http://www.mikrotik.com/download/neighbour.zip
than install to your pc
regards
Hasbullah.com
---
Posted: Mon May 07, 2007 12:10 pm
by davidefulvio
i have tried to connect with mac telnet and this the answer:
jan/01/2000 00:41:32 system,error,critical login failure for user and via winbox
Terminal linux detected ,using multiline input mode
[admin@Mikrotik] > user print
Flags X-disabled
# NAME GROUP ADDRESS
0 ;;; system default user
admin full 0.0.0.0/0
Posted: Mon May 07, 2007 12:28 pm
by Diganet
i have tried to connect with mac telnet and this the answer:
jan/01/2000 00:41:32 system,error,critical login failure for user and via winbox
Terminal linux detected ,using multiline input mode
[admin@Mikrotik] > user print
Flags X-disabled
# NAME GROUP ADDRESS
0 ;;; system default user
admin full 0.0.0.0/0
Login as admin
/Henrik
Posted: Mon May 07, 2007 12:39 pm
by balimore
----
yes, friend you have login in as
admin with full permission, now you can start from here
http://www.mikrotik.com/testdocs/ros/2. ... /basic.php
i think should working...
regards
Hasbullah.com
----
Posted: Mon May 07, 2007 12:42 pm
by davidefulvio
I have tried to access through telnet and i access all functions. I have changed IP address and then I have tried to access through winbox downloaded through HTTP but this disconnect every 30 sec and it does not make me to access all functions
Posted: Mon May 07, 2007 12:53 pm
by balimore
----
when you try login in with ip address, your PC must same range subnet and netmask of your router address.
with mac-telnet or mac-winbox diffrence subnet is no problem
regards
Hasbullah.com
----
Posted: Mon May 07, 2007 1:27 pm
by davidefulvio
i set this parameters:
ip address 192.168.0.1
subnet mask 255.255.255.0
gateway 192.168.0.254 (ip address of router)
is it ok?