NUC connects with hAP lite via Swith only. w/o switch: no link. MDIX-problem?
Posted: Sat Mar 21, 2020 4:54 pm
I have a hAP lite in bridge mode connected with two PCs and an upsteam router. An Intel NUC NUC8i5BEH works only if connected via Switch. If I connect NUC directly to hAP the cable test shows "no link". Looks like auto sensing / MDIX problem. As soon as I connect a switch in between it works. How can I check which end causes the issue?
full config is attached.
Code: Select all
[admin@MikroTik_hAP_lite] > /interface ethernet monitor ether4
name: ether4
status: no-link
auto-negotiation: done
advertising: 10M-half,10M-full,100M-half,100M-full
link-partner-advertising:
[admin@MikroTik_hAP_lite] > /interface ethernet monitor ether4
name: ether4
status: no-link
auto-negotiation: done
advertising: 10M-half,10M-full,100M-half,100M-full
link-partner-advertising: