Page 1 of 1
Audience LTE6 Config Problem
Posted: Tue Mar 31, 2020 6:37 am
by provoshane
I am trying to setup an Audience LTE6 Kit and it is connected to AT&T here in the US, but the throughput is almost non-existant. I have a Netgear Nighthawk next to it that pulls down 30 + Mbps but the MT is barely getting 1 Mbps at most. I know I must be doing something wrong, but I have no idea what it is. Can anyone point me toward a post or documentation for troubleshooting this?
Re: Audience LTE6 Config Problem
Posted: Wed Apr 01, 2020 9:35 pm
by rcch
how are your signal strength compared to netgear? I also have issue that my xyxel7460 gives stronger signals than mikrotek eventough on paper mikrotek should do much better
Re: Audience LTE6 Config Problem
Posted: Thu Apr 30, 2020 12:50 am
by SiB
I am trying to setup an Audience LTE6 Kit and it is connected to AT&T here in the US, but the throughput is almost non-existant. I have a Netgear Nighthawk next to it that pulls down 30 + Mbps but the MT is barely getting 1 Mbps at most. I know I must be doing something wrong, but I have no idea what it is. Can anyone point me toward a post or documentation for troubleshooting this?
You should try few APN like: phone , broadband , Broadband , NXTGENPHONE
Re: Audience LTE6 Config Problem
Posted: Mon May 04, 2020 1:18 pm
by WeWiNet
Have you updated your audience to latest LTE modem firmware should be V.x.25 in the US as well ?
--> You need to do this in terminal. Interface/LTE /firmware-upgrade YOUR-LTE-NAME...