MikroTik

Hello Everybody,

I'm new in the mikrotiok world, ans i struggle to understand some vlan stuff.

I want to make this infrastructure :

1. Fist thing, I want a VRRP on the interfaces sfp1, 2 & 3. So i created a bridge (bridge_lan) with my 3 sfp inside. Then i setup the vrrp and the dhcp on the bridge (bridge_lan). It's looks like it's working. But it's the proper way to do it ?

2. I also want VRRP on my vlans. Then, I created bridge for each vlan (bridge_vlandata, bridge_vlanserver...) , then setup vrrp and the dhcp on the bridge created before. But after i'm not sure of what to do. Do a bridge vlan, using the bridge_vlan and the interface sfp1, 2 & 3 tagged ?

Thank you for you help.

1. No it does not seem correct...
I would setup VRRP on SFP1, on SFP2 and on SFP3 (Three different VRRPs) for CCR1 and CCR2... CCR1 would be set with higher Priority in order to be the Master and in case something happened to SFP1 of the CCR1 then SFP1 of CCR2 would start...

2. When working with VLANs you dont set the DHCP to the Bridge but to the VLAN or VLANs Interfaces...

Some sources you should check:
https://wiki.mikrotik.com/wiki/Manual:Interface/VRRP
https://wiki.mikrotik.com/wiki/Manual:VRRP-examples
viewtopic.php?t=143620

Hello,

Did you resolved this?

solution?