I'm using Mikrotik since 2004 and I had pretty much 0 problems with any configs i made. RB532 still works today! However I faced a challenge that even Mikrotik support is not capable to solve. Not a surprise as whole internet is full of reported CAPsMan issues. So to the point. I have 2 devices at home RB4011 and CAP AC (2nd floor). If I setup each device wot work ar as independant AP all works well. But if I enable CAPsMAN, 80% of devices no longer able to discover SSID. I ran WiFi analyser on Android phone. sometime it picks up SSID sometime not. After restarting CAPsMAN several times. CAP AC on 2nd floor can never bee discovered. I very well aware to wait for MT to finish scan. and I see on interface comments that interface is managed by CAPsMAN, channel: xxxxx, SSID:
I have sent suppout before and after enabling capsman to support. but support refereed to the documentation. My config is very simple. Local forwarding, no fixed channles.
Below is my config
Code: Select all
[admin@AP pagrindinis] > /caps-man provisioning print
Flags: X - disabled
0 ;;; 2.4GHz 802.11g capabale radios
radio-mac=00:00:00:00:00:00 hw-supported-modes=g identity-regexp="" common-name-regexp="" ip-address-ranges="" action=create-dynamic-enabled master-configuration=Mexico 2G Config
slave-configurations="" name-format=prefix-identity name-prefix="2.4GHz-"
1 ;;; 5GHz 802.11ac capable radios
radio-mac=00:00:00:00:00:00 hw-supported-modes=ac identity-regexp="" common-name-regexp="" ip-address-ranges="" action=create-dynamic-enabled master-configuration=Mexico 5G config
slave-configurations="" name-format=prefix-identity name-prefix="5GHz-"
[admin@AP pagrindinis] /caps-man> configuration print
0 name="Mexico 2G Config" mode=ap ssid="Mexico2" hide-ssid=no country=lithuania security=CAPsMAN security datapath=datapath1 channel=2Gch1 rates=2G GN rates only rates.basic="" rates.supported=""
1 name="Mexico 5G config" mode=ap ssid="Mexico5" hide-ssid=no country=lithuania installation=indoor distance=indoors security=CAPsMAN security datapath=datapath1 channel=5Gch1 rates.basic=""
rates.supported=""
[admin@AP pagrindinis] /caps-man> channel print
0 name="2Gch1" band=2ghz-g/n extension-channel=Ce tx-power=10 skip-dfs-channels=yes
1 name="5Gch1" band=5ghz-n/ac skip-dfs-channels=yes
[admin@AP pagrindinis] /caps-man> datapath print
0 name="datapath1" bridge=bridge-local local-forwarding=yes
[admin@AP pagrindinis] /caps-man> security print
0 name="CAPsMAN security" authentication-types=wpa2-psk,wpa2-eap encryption=aes-ccm group-encryption=aes-ccm group-key-update=1h passphrase="***************" disable-pmkid=yes
[admin@AP pagrindinis] /caps-man> rates print
0 name="2G GN rates only" basic=6Mbps supported=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,54Mbps
RB4011
Code: Select all
[admin@AP pagrindinis] > interface wireless cap print
enabled: no
interfaces: wlan5G,wlan2G
certificate: none
lock-to-caps-man: no
discovery-interfaces: bridge-local
caps-man-addresses:
caps-man-names:
caps-man-certificate-common-names:
bridge: none
static-virtual: no
requested-certificate: CAP-B869F4C57D7A
Code: Select all
[admin@CAP AC 2a] > /interface wireless cap print
enabled: no
interfaces: wlan5G,wlan2G
certificate: none
lock-to-caps-man: no
discovery-interfaces: bridge1
caps-man-addresses:
caps-man-names:
caps-man-certificate-common-names:
bridge: none
static-virtual: no
