MikroTik

Posted: **Sat Jun 13, 2020 9:11 pm**

Is there any way to configure the following parameters in the ppp interface, i have a 3g usb modem attached that will not connect to the data network unless its configured like below(on android)

APN: internet-32
MCC: 222
MNC: 10
APN Type: default,sup,dun
APN protocol : IPv4/IPv6
APN roaming protocol: IPv4/IPv6
MVNO type: GID
MVNO value: 20

i think the most important is the APN Type, MVNO type and MVNO value

Posted: **Sun Jun 14, 2020 7:06 pm**

Have you tried Advanced Mode, and also therein in profile?

Posted: **Mon Jun 15, 2020 1:55 am**

Have you tried Advanced Mode, and also therein in profile?

sure, but nothing is found there that barely resembles any of this parameters: APN Type, MVNO type and MVNO value

Posted: **Thu Jan 19, 2023 8:37 pm**

Did you ever figure this out, particularly the APN Type?

MikroTik

ppp interface configuration parameters, APN Type, MVNO type, MVNO value

ppp interface configuration parameters, APN Type, MVNO type, MVNO value

Re: ppp interface configuration parameters, APN Type, MVNO type, MVNO value

Re: ppp interface configuration parameters, APN Type, MVNO type, MVNO value

Re: ppp interface configuration parameters, APN Type, MVNO type, MVNO value