MikroTik

Hi,

is it currently possible (with a OmniTik 5 AC) to configure a regular 802.11ac Accesspoint for normal Clients but also configure a nv2 -protocoll enabled virtual accesspoint for terminating a PtP Link to another Mikrotik XT Lite5?
Or are both transmission protocols incompatible that this could work with one Hardware NIC and two VAPs?

Thanks a lot for clearyfing.

Cheers

4920441

Had the same need on hAp ac2 ...

Station bridge is master nv2
Ap bridge is slave in 802.11ac

But is incompatible

Nv2 ist working well for ac, why don’t your 802.11?

Nv2 not working for ac ???.... well problems seem to be gone since 6.45.6. Better / worse it all depends now!

Had troubles with 802.11ac connections that failed every few hours when using 802.11ac. Done all tuning I know and understand (AMSDU=2048,( where now I think for “ac” this is just not even used as the possible values are around 3500,5500,11000), hw-retries=15, rts/cts, noise immunity, long preamble, higher disconnect timeout …..) not much of an improvement , not statistically relevant. Most logged disconnect error “no beacon received”. Trimming the tree in between did not improve it either.
Switched to Nv2 for AP SXTSA5-13 and stations SXTsq 6,7 and 11. (13-14 link had no problem). Stable now, already 3 full days, weather storm included. CCQ even better than the short 13-14 link.


Round trip delay augmented with 2msec.