i have 2 bgp peer. from this peer i will received same dst-address at routing table, so i need configure distance parameter for failover....please help

i have 2 bgp peer. from this peer i will received same dst-address at routing table, so i need configure distance parameter for failover....please help

hello guys....please advice....
is this can work with routing filter...action=accept set-distance=100 for example

that will work, however you should already be receiving both routes, and one is not active while the other is correct? The AS PATH length will determine which one it uses most likely. Are you getting both routes via BGP and they are showing in your route table ?

that will work, however you should already be receiving both routes, and one is not active while the other is correct? The AS PATH length will determine which one it uses most likely. Are you getting both routes via BGP and they are showing in your route table ?

yes...i will getting route table vua BGP...

i all...
it work with routing filter set distance parameter..but at interface 1 see unknown..
please advice