Page 1 of 1
610-8G-2S+IN - missing temperature
Posted: Sat Mar 13, 2021 7:02 pm
by jamsden
Hi everybody,
I just upgraded SwOS to 2.13, and reading the changelog from the switch itself, i read:
What's new in v2.13:
...
*) CSS610: report temperature under System tab;
...
Is it only me or there's no temperature in System tab?
In general this version looks really better, I am now able to connect to the console every time I try to (!) :).
Re: 610-8G-2S+IN - missing temperature
Posted: Sat Mar 13, 2021 9:52 pm
by JJT211
On my Netpower 7r (also a CSS610), im getting the temp just fine. Its located in the system tab under the health section
Re: 610-8G-2S+IN - missing temperature
Posted: Sat Mar 13, 2021 11:20 pm
by jamsden
Thank you, in my System tab there’s no temperature info.
Re: 610-8G-2S+IN - missing temperature
Posted: Sun Mar 14, 2021 1:45 am
by nannou9
No health/temp option in my case too.
Re: 610-8G-2S+IN - missing temperature
Posted: Mon Mar 15, 2021 11:32 am
by mbelanger
Not just you. No Health section under System for me with 2.13.
In fact, the only reference to temperature on any tab is under the SFP tab, which are running a toasty 50C & 60C, with two S+RJ10s, though only one is active at 1G.
-MB
Hi everybody,
I just upgraded SwOS to 2.13, and reading the changelog from the switch itself, i read:
What's new in v2.13:
...
*) CSS610: report temperature under System tab;
...
Is it only me or there's no temperature in System tab?
In general this version looks really better, I am now able to connect to the console every time I try to (!) :).
Re: 610-8G-2S+IN - missing temperature
Posted: Mon Mar 15, 2021 10:44 pm
by Hominidae
...same here....I think this is only with the outdoor Version of the CSS610 then?
Re: 610-8G-2S+IN - missing temperature
Posted: Tue Mar 16, 2021 6:10 pm
by jamsden
...same here....I think this is only with the outdoor Version of the CSS610 then?
It looks like it.