MikroTik

Hi all,
I've observed that when using DFS ( 5GHz, no radar detection, domain Italy), MT starts scan at frequenquencies not allowed by the regulatory domain in outdoor usage (5180, 5200 MHz) and stops scanning without searching at higher frequencies. Is there a way to exclude some channels for the scan interval in order to "force" MT to scan only the allowed domain (5470-5725 MHz in Italy)?

Rgds

use the scan-list - specify the scanlist to use freqeuncy range from 5475-5725

Ok great,
thank you for reply Uldis.
I thought it was only a selection menu and that it is not possible to write down a frequency range.
Now it works and scan only selected range.

Rgds