[FEATURE REQUEST] EDIT SWITCH CONFIG AFTER BACKUP RESTORE, BUT BEFORE REBOOT
Posted: Thu May 13, 2021 5:38 pm
MikroTik support told me to put a post here, so comment if you think you want this.
I have a ton of switches, and I am provisioning all the time.
When I provision I restore a backup from a switch that is the closest to what I would want. It reboots, and then I have a laptop that I use to direct connect to the switch, and finish provisioning.
I want to be able to edit some settings before the device reboots. IE the settings restore, but until I hit a final apply somewhere, nothing happens, and I can edit them.
I have a ton of switches, and I am provisioning all the time.
When I provision I restore a backup from a switch that is the closest to what I would want. It reboots, and then I have a laptop that I use to direct connect to the switch, and finish provisioning.
I want to be able to edit some settings before the device reboots. IE the settings restore, but until I hit a final apply somewhere, nothing happens, and I can edit them.