MikroTik

Hi everyone I upgraded the driver to WifiWave2 on my Audience, wireless is indeed much faster now, but I cannot find the option that I really need - "default-authenticate"

Previously my 2.4GHZ wlan had "default-authenticate" unticked, so only allowed clients from the access lists were able to connect to it, as I want as many device as possible to be on the 5GHZ, otherwise they just like to comeback to 2.4GHZ.

It looks like this is no longer supported or how do I set it up, please ?

thank you

I can't find VLAN tags.

I have my radios get stuck on selecting channel.

It's a BETA AT THIS POINT.

I can't find VLAN tags.

I have my radios get stuck on selecting channel.

It's a BETA AT THIS POINT.

yeah seems like vlan tags cannot to assigned directly under the wireless interfaces now, use bridge config for them

If the audience is "just a WAP" in my config...

So make a bridge and put the VLAN and wireless interface in it?

I think I will just put the Audience back in it's box for now.

If the audience is "just a WAP" in my config...

So make a bridge and put the VLAN and wireless interface in it?

I think I will just put the Audience back in it's box for now.

Here is how you can do it, don't use vlan tags under wireless interfaces, i did not use them even with the old driver, instead do like so:

create one bridge, only one is needed, add wireless and physical ports to it, notice the tags I am using (10 and 20 for access ports)

/interface bridge port
add bridge=bridge ingress-filtering=no interface=ether1-trunk
add bridge=bridge ingress-filtering=no interface=ether2 pvid=10
add bridge=bridge interface=wlan10_main_2.4GHz pvid=10
add bridge=bridge interface=wlan10_main_5.0GHz pvid=10
add bridge=bridge interface=wlan10_main_5.0GHz+ pvid=10
add bridge=bridge interface=wlan20_guest_2.4GHz pvid=20
add bridge=bridge interface=wlan20_guest_5.0GHz+ pvid=20

then enable vlan filtering in the bridge section:
am basically splitting the interfaces on access and trunk, all wlans are access (I got 6: 3 phisical + 3 virtual wlans) and I tell the interfaces: some belong to vlan 10, the other to vlan 20

/interface bridge vlan
add bridge=bridge tagged=ether1-trunk,bridge untagged=ether2,wlan10_main_2.4GHz,wlan10_main_5.0GHz,wlan10_main_5.0GHz+ vlan-ids=10
add bridge=bridge tagged=ether1-trunk,bridge untagged=wlan20_guest_2.4GHz,wlan20_guest_5.0GHz+ vlan-ids=20

Hi everyone I upgraded the driver to WifiWave2 on my Audience, wireless is indeed much faster now, but I cannot find the option that I really need - "default-authenticate"

Previously my 2.4GHZ wlan had "default-authenticate" unticked, so only allowed clients from the access lists were able to connect to it, as I want as many device as possible to be on the 5GHZ, otherwise they just like to comeback to 2.4GHZ.

It looks like this is no longer supported or how do I set it up, please ?

I think you can achieve the same in WifiWave2. In access list create one last empty entry with Interface= your 2.4GHZ network and Action=reject being set. It must be the last entry in your access list .. meaning it kicks in after all other accept list entries with your allowed clients/MAC addresses get processed.