Dear ALL,
I'm setting the MPLS + OSPF network, the CPE are connecting to the two PE router, the CPE can receive the dst address from the two PE router, but i want to force the traffic via the PE router 1(10.1.8.1) , how to do this?
TungHo
OSPF receive one dst-address with two gateway
You do not have the required permissions to view the files attached to this post.
-
-
joegoldman
Forum Veteran
- Posts: 775
- Joined:
Re: OSPF receive one dst-address with two gateway
You might be able to use filters to adjust distance on one vs the other imported route - as changing the interface cost will affect both.
Alternatively, deliver both PE's on a separate ports, or if it must remain single port, split it out in VLANs, this way you can adjust the cost of PE2 slightly higher so it always prefers PE1.
Alternatively, deliver both PE's on a separate ports, or if it must remain single port, split it out in VLANs, this way you can adjust the cost of PE2 slightly higher so it always prefers PE1.
Re: OSPF receive one dst-address with two gateway
i tried to use the filter to adjust distance, but donesnt work. Is there possible to receive two same dst-address split to two route?You might be able to use filters to adjust distance on one vs the other imported route - as changing the interface cost will affect both.
Alternatively, deliver both PE's on a separate ports, or if it must remain single port, split it out in VLANs, this way you can adjust the cost of PE2 slightly higher so it always prefers PE1.
our upstream provide said the circuit cant support vlan passthrough and Q-in-Q,