Page 1 of 1
Simple queues don't work with Ares
Posted: Fri Sep 21, 2007 12:40 pm
by nowires
I have attached one rule, but there are many clients like this. No matter the queue, they uses at least 100 kbps of upload.
Re: Simple queues don't work with Ares
Posted: Sun Sep 23, 2007 9:57 pm
by winxp2000
Could you post you setting detail of the simple queue ?
We can not see any issue about you simple queue from your picture.
Re: Simple queues don't work with Ares
Posted: Mon Sep 24, 2007 10:35 pm
by maximan
Make a torch to this address
M.
Re: Simple queues don't work with Ares
Posted: Tue Sep 25, 2007 4:00 am
by omega-00
Are you setting both the default AND max value to 32k? (they're on 2 separate tabs)
Re: Simple queues don't work with Ares
Posted: Wed Sep 26, 2007 1:59 am
by laze81
I had the same problem
yesterday I buyed new MT v3.0rc5 for my new sata and just restore backup from 2.9 to 3.0rc5 (but with same problem with p2p)
today made a fully reset and configured it from beginning(without restore)
For now queues working ok but still can't limit Ares traffic
Re: Simple queues don't work with Ares
Posted: Tue Oct 09, 2007 11:14 pm
by titius
You cant limit all encrypted traffic, BUT, make mangle rules, first mangle with connection mark, then make packet mark with firstly created connection mark for IP or range of IP addresses, in that way you can limit every user with rate that you want.
At least it is how I did it, and it works fine.