MikroTik

Hello Evreyone i have RB4011
ihave 150MB speed

Issues : when i connect the internet throw pppoe connectiuon i got 80-90 just ??
when i cponnect direct i got 150 ?


Fasttrack=Disable
MTU=1492
Firewall Rule = 0

It's normal to see a reduction in the internet speed when using a PPPoE connection, as the connection requires some overhead for the authentication process.

However, a reduction of 60-70 MBps is quite significant and there could be a few reasons for this. Here are some things you can try to troubleshoot the issue:

• Check the PPPoE connection settings on your router to make sure they are correct.

• Check if there are any other devices connected to your network that may be using bandwidth and causing congestion.

• Try connecting to the internet using a wired connection instead of a wireless connection, as this can often provide a more stable and faster connection.

• Check if there are any issues with your internet service provider or with the cables or equipment used to connect to the internet.

• Check if the MTU value is set correctly. A value that is too low can cause problems with the PPPoE connection.

• Check if the firewall rules are configured correctly and not blocking any necessary traffic.

I hope this helps!

Thanks You alot

the proplem sloved

ISSUES : in the firewall managle rule of load balance in dst adress i just replace router ip 192.168.88.0/24 to the PPPOE IP POOL 192.168.200.0/24 and after that i got full speed

Yes, those rules were clearly broken in the config you've shown us in the first post.
Oh, wait..