MikroTik

Hi,

2 days ago I upgraded an AP wich had an 112 to a 333, since then I've been getting duplicate pings on the clients that have lower signals, arround -85 Db

I'm running v3 rc4, but tried v3 rc6 with same results. Also, all of the 14 clients on that AP run 2.9.46

Any ideas?

any bridges, loops in the network?

They’re no bridges on the network. We do have redundant paths using OSPF, but that's on the backbone, from it, via Ethernet we connect this AP, it does not have OSPF, it only uses 2 interfaces, the Ethernet to connect to the backbone and one Ubiquiti XR5 on a /27 IP net to connect to all the 14 clients. We test using that router to ping the wireless interface of the client, there is nothing but air in between them.

Thanks,

Jorge

By the way, could this be related to heat issues? It's just that I noticed that the problems are worse during hottest hours.

Ok, now it's even worse, now it's dropping clients, you can see them registered but you cannot ping them from the AP.

Is this a software or hardware malfunction? Should I just go back to using the 112 with 2.9.46?

Thanks

Jorge

Well, ever since I upgraded to 3 RC 6 the clients don't drop, so something was fixed I guess.