I previously used RB2011 with same transceiver to connect to D-Link DGS-1210-16 (using identical module)
Had no issue. I expected RB4011 to carry on this setup
But while the light shows in the transceiver, and the transceiver is recognized, I simply get no-link
Code: Select all
name: sfp1
status: no-link
auto-negotiation: done
advertising:
link-partner-advertising:
sfp-module-present: yes
sfp-rx-loss: no
sfp-tx-fault: no
sfp-type: SFP-or-SFP+
sfp-connector-type: LC
sfp-link-length-om1: 70m
sfp-link-length-om2: 150m
sfp-vendor-name: FINISAR CORP.
sfp-vendor-part-number: FTLF8524P2BNV-BR
sfp-vendor-revision: A
sfp-vendor-serial: U9G28NJ
sfp-manufacturing-date: 06-04-21
sfp-wavelength: 850nm
sfp-temperature: 45C
sfp-supply-voltage: 3.315V
sfp-tx-bias-current: 7mA
sfp-tx-power: -4.492dBm
sfp-rx-power: -4.732dBm
eeprom-checksum: good
eeprom: 0000: 03 04 07 00 00 00 01 20 40 0c 15 01 2a 00 00 00 ....... @...*...
0010: 0f 07 00 00 46 49 4e 49 53 41 52 20 43 4f 52 50 ....FINI SAR CORP
0020: 2e 20 20 20 00 00 90 65 46 54 4c 46 38 35 32 34 . ...e FTLF8524
0030: 50 32 42 4e 56 2d 42 52 41 20 20 20 03 52 00 d2 P2BNV-BR A .R..
0040: 00 32 00 00 55 39 47 32 38 4e 4a 20 20 20 20 20 .2..U9G2 8NJ
0050: 20 20 20 20 30 36 30 34 32 31 20 20 68 d8 01 d7 0604 21 h...
0060: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ........ ........
*
0080: 5f 00 e7 00 5a 00 ec 00 98 58 69 78 90 88 71 48 _...Z... .Xix..qH
sebus
