Page 1 of 1
wifiwave2 connect-list
Posted: Wed Oct 11, 2023 8:38 pm
by kubla36
Are there plans to support connect-list in wifiwave2? Or is there an alternate method of accomplishing similar things?
I used it to limit MAC uplinks in wireless previously (have a new AP that only supports wifiwave2).
Re: wifiwave2 connect-list
Posted: Wed Feb 05, 2025 3:41 pm
by MikeTkatchouk
Hello friends. Is there any news on this issue two years later?
I tried to create a subinterface and make it in station mode. But it does not connect to the network and the scan does not produce results. My device is HAP AC2.
Re: wifiwave2 connect-list
Posted: Wed Feb 05, 2025 5:18 pm
by mkx
I tried to create a subinterface and make it in station mode.
Only master interface can realistically be used in station mode ... because only master interface can scan frequencies for APs.
Re: wifiwave2 connect-list
Posted: Wed Feb 05, 2025 5:46 pm
by MikeTkatchouk
What then should I do if I need to connect to different ssids depending on their availability? This works on the old version, I would like to use it on the new one. or just downgrade?
Re: wifiwave2 connect-list
Posted: Wed Feb 05, 2025 7:40 pm
by mkx
It seems that access-list subtree should allow to set device in station mode to behave similarly to legacy wireless with connect-list, I seem to remember a few discussions about it. Sadly I din't find any useful topic right now ... and I never tried it myself. So let's hope that somebody with right experience drops by ...