2.4GHz-G-Turbo Missing in RBs?

ilius168 · Sun Dec 02, 2007 12:33 am

Hi All,
just realised, 2.4GHz-G-Turbo mode has been missing in RBs, but available when using PC Router with wireless PCI (AR5413 chipsets), v.2.9.27 & 2.9.38

Can someone from MT please confirm? or if there're settings that i've missed with RB?

Thanks!

ilius168 · Sun Dec 02, 2007 12:39 am

Oops, wrong room, can someone please move my post to wireless section?

Mon Dec 03, 2007 12:45 pm

Make sure that frequency-mode and regulation-mode are the same on both and 2.4GHz-Turbo is allowed and supported by card.

hebeda · Tue Dec 04, 2007 3:37 pm

make sure that your card is capable to support Super G mode .... AR2413 doesnt support 108 mbps , the AR2414 BB MAC card does support 108 mbps ... since the mikrotik software shows always AR2413 also for AR2414 cards dont get confused and check your card and manufacturer datasheet for more information what chipset your card is using.

ilius168 · Thu Dec 06, 2007 3:06 am

I'm using NMP8602 mPCI on both PC Router and my RBs. Same mPCI same chipset. Both operating using superchannel frequency mode (i assume there's no country restriction on this mode right?).

Here are some info on PC Router, v.2.9.38

 0 interface-type=Atheros AR5413 
   chip-info="mac:0xa/0x5, phy:0x61, a5:0x63, a2:0x0, eeprom:0x5003" 
   pci-info="01:04.0" capabilities=tx-power-control,ack-timeout-control,
                                   virtual-ap,alignment-mode,noise-floor-
                                   control,scanning,burst-support,nstreme,
                                   sniffing,compression,power-channel 
   default-periodic-calibration=enabled 
   supported-bands=2ghz-b,5ghz,5ghz-turbo,2ghz-g,2ghz-g-turbo,5ghz-10mhz,5ghz-
                   5mhz,2ghz-10mhz,2ghz-5mhz

and RB333, v.3.0rc6

 0 interface-type=Atheros AR5413 
   chip-info="mac:0xa/0x4, phy:0x61, a5:0x63, a2:0x0, eeprom:0x5003" 
   pci-info="00:11.0" capabilities=tx-power-control,ack-timeout-control,
                                   virtual-ap,alignment-mode,noise-floor-
                                   control,scanning,burst-support,nstreme,
                                   sniffing,power-channel,wmm 
   default-periodic-calibration=enabled 
   supported-bands=2ghz-b,5ghz,2ghz-g,5ghz-10mhz,5ghz-5mhz,2ghz-10mhz,2ghz-
                   5mhz

Thu Dec 06, 2007 10:14 am

upgrade to the RB333 to the newest RouterOS version and check again.

2.4GHz-G-Turbo Missing in RBs?

2.4GHz-G-Turbo Missing in RBs?

Re: 2.4GHz-G-Turbo Missing in RBs?

Re: 2.4GHz-G-Turbo Missing in RBs?

Re: 2.4GHz-G-Turbo Missing in RBs?

Re: 2.4GHz-G-Turbo Missing in RBs?

Re: 2.4GHz-G-Turbo Missing in RBs?

Who is online