MikroTik

Posted: **Sat Aug 24, 2024 3:35 am**

Hi all,
two MT devices connected over the Internet by Wireguard, all working fine.

I have some vlans on Router1, I want Router2 to use, what is the accepted way of doing this? Was thinking of an EOIP tunnel but looking for other, possibly better ideas? Wanting to use Capsman across the WG link also from R1 to devices on R2.

TIA

Posted: **Sat Aug 24, 2024 4:03 am**

Why? just uses wireguard.
On allowed IPs, router1, put the remote subnets coming in.
On allowed IPs router2, put the remote subnets going to
On each router put IP routes main table, interface wireguard, dst-remote subnet...
Firewall rules as required.

Posted: **Sat Aug 24, 2024 10:57 am**

Hi all,
two MT devices connected over the Internet by Wireguard, all working fine.

I have some vlans on Router1, I want Router2 to use, what is the accepted way of doing this? Was thinking of an EOIP tunnel but looking for other, possibly better ideas? Wanting to use Capsman across the WG link also from R1 to devices on R2.

TIA

L2 Ethernet, VXLAN

Posted: **Wed Aug 28, 2024 2:15 pm**

L2 Ethernet, VXLAN

Thanks, this is what I wanted.

MikroTik

VLANs over Wireguard- how?

VLANs over Wireguard- how?

Re: VLANs over Wireguard- how?

Re: VLANs over Wireguard- how?

Re: VLANs over Wireguard- how?