MikroTik

Hello everyone.

Please can you help me, this is going to kill me.

I need to have 2 services running via one external IP, each service using different ports, on different devices. Some udp, some tcp. How would this be done?

Pls, i know this might seem simple, but i have to get this working. Everything i have tried does not work.

Maby an expample that i can change the ips to suit my needs.

Thanks a mill

firewall - nat - add - dstnat - dst-address=your_external_address, dst-port=your_port, action = dst-nat, to-addresses = your_internal_ip, to-ports = your_internal_port

Also make sure Connection Tracking is enabled. NAT won't work without it.

I have the same problem.

my firewall config:
my ip config connection tracking
Please help!!!

I have the same problem.

my firewall config:

Code: Select all

Flags: X - disabled, I - invalid, D - dynamic 
 0   chain=srcnat action=masquerade src-address=10.50.0.0/24 

 1   chain=dstnat action=dst-nat to-addresses=10.50.0.2 to-ports=4899 
     in-interface=ether1 dst-port=7001 protocol=tcp

my ip config

Code: Select all

 #   ADDRESS            NETWORK         BROADCAST       INTERFACE              
 0   40.0.10.251/24     40.0.10.0       40.0.10.255     ether1                 
 1   10.50.0.1/24       10.50.0.0       10.50.0.255     ether4

connection tracking

Code: Select all

enabled: yes
      tcp-syn-sent-timeout: 5s
  tcp-syn-received-timeout: 5s
   tcp-established-timeout: 1d
      tcp-fin-wait-timeout: 10s
    tcp-close-wait-timeout: 10s
      tcp-last-ack-timeout: 10s
     tcp-time-wait-timeout: 10s
         tcp-close-timeout: 10s
               udp-timeout: 10s
        udp-stream-timeout: 3m
              icmp-timeout: 10s
           generic-timeout: 10m
             tcp-syncookie: no
               max-entries: 524288
             total-entries: 4

Please help!!!

This should help you

chain=dstnat dst-address=40.0.10.251 action=dst-nat to-addresses=10.50.0.2 to-ports=4899 dst-port=7001 protocol=tcp

also got a problem with dst nat. Its set up like Chupaka posted and connection tracking is on.

When I connect to my external ip from another computer its able to display some of the page, but very very slowly and the pictures fails. Also I noticed that IE displayed my internal ip at the status bar when it loads the page..

Im using a rb112, ros v3.3. This setting worked fine earlier (v 2-9), but as I didnt need the dst nat for some time it was disabled until now..