I HAVE A RB133 IN APBRIDGE MODE AND I AM USING ANOTHER RB133 AS A CLIENT I HAVE TO ACTIVATE WDS OTHERWISE THEY DONT COMMUNICATE WITH EACH OTHER IF I USE WINBOX I CAN SEE BOTH POINTS AND I OBTAIN IP FROM MY ROUTER BUT CANT GET ACCESS TO PAGES AND OTHER INTERNET ACCESS UNTIL I ACTIVATE WDS, I WAS USING A SENAO BEFORE AS A CLIENT AND WAS WORKING FINE WITHOUT WDS.
I THINK I HAVE WRONG CONFUGURATION
PLEASE HELP

THANK YOU

please post your /interface bridge and /interface wireless configurations

Flags: X - disabled, R - running
0 R name="bridge1" mtu=1500 arp=enabled mac-address=00:0B:6B:57:08:EE stp=yes
priority=32768 ageing-time=5m forward-delay=15s
garbage-collection-interval=5s hello-time=2s max-message-age=20s
Flags: X - disabled, R - running
0 R name="wlan1" mtu=1500 mac-address=00:0B:6B:57:08:EE arp=enabled
disable-running-check=no interface-type=Atheros AR5213 radio-name=""
mode=bridge ssid="TICC II" area="" frequency-mode=manual-txpower
country=mexico antenna-gain=0 frequency=2432 band=2.4ghz-b
scan-list=default rate-set=default
supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps
supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,
54Mbps
basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007
ack-timeout=dynamic tx-power-mode=default noise-floor-threshold=default
periodic-calibration=default periodic-calibration-interval=60
burst-time=disabled dfs-mode=none antenna-mode=ant-b wds-mode=dynamic
wds-default-bridge=bridge1 wds-default-cost=100 wds-cost-range=50-150
wds-ignore-ssid=no update-stats-interval=disabled
default-authentication=no default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 proprietary-extensions=post-2.9.25
hide-ssid=yes security-profile=default disconnect-timeout=3s
on-fail-retry-time=100ms preamble-mode=both compression=no
allow-sharedkey=no

I HAVE SIGANALS AROUND -50 AND TX/RXCCQ AROUND 90S

THANKS FOR HELPING