MikroTik

how to configure burst for my client in pppoe server?

Hi trottolino1970,

Check the following link:
http://wiki.mikrotik.com/wiki/Hotspot%2 ... priorities

Same scenario is working fine with pppoe

Regards,
Alaa

Hi trottolino1970,

Check the following link:
http://wiki.mikrotik.com/wiki/Hotspot%2 ... priorities

Same scenario is working fine with pppoe

Regards,
Alaa

and to show me burst for pppoe?

u have to configure burst in a radius server..

try using mikrotik's dictionary http://www.mikrotik.com/documentation// ... y.mikrotik

u have to configure burst in a radius server..

try using mikrotik's dictionary http://www.mikrotik.com/documentation// ... y.mikrotik

and you can also configure it using ROS local Profiles

u have to configure burst in a radius server..

try using mikrotik's dictionary http://www.mikrotik.com/documentation// ... y.mikrotik

and you can also configure it using ROS local Profiles

brust.jpg

Queue.jpg

if i put this configuration, the ppoe reboot always

what do you mean with PPPoE reboot ???

what do you mean with PPPoE reboot ???

pppoe is not stable

what version do you use ??

what version do you use ??

2.9.42

its work for me in 3.4 and 2.9.50

Can you post your pppoe profile configuration ???

its work for me in 3.4 and 2.9.50

Can you post your pppoe profile configuration ???

56k/1024k 56k/1024M 56k/2048k 1 56k/1024k

Burst should work fine at 3.7 version.

Hi ;
i need to use the bust to let the users reach reasonable speed during the first min of download or browsing to let them get what they need and then the server reduce the speed so they not affect other users .
i tried doing this many times but i didn't succed , i am using 3.6 now .
here is a photo attached showing what i did today to test after i read this article .
is it correct ?
with best regards .

ahmedsaffar76, you are only bursting for 2seconds. That is too small a time to see any real boost. Increase the 2sec to 10sec or more to see it's effect.

ahmedsaffar76, you are only bursting for 2seconds. That is too small a time to see any real boost. Increase the 2sec to 10sec or more to see it's effect.

Hi ;
thanks for your reply .
this is just to check if the speeds are correct and each one on place .
i tried this before with 60 sec , as i remember it didn't work .
so , here need to ask if i put time like 30 sec .
will it work correctly ?
with best regards .

Yes, burst should work with 30 seconds and 60 seconds too.
Here is by the way great explanation about the burst operation,
http://wiki.mikrotik.com/wiki/Burst